Sidney Stoat

Water Spitter Figurine

Sidney sits on the side of your pond spraying jets across the water to create beautiful ripple effects

Features
Setting up and running
Specification
  • Freedom to instantly run without the need for mains power
  • Solar panel with integrated battery backup system for greater running time in poor weather
  • Gently pulsing water jet creates a relaxing attractive water feature

 

Rosie Hedgehog Feature Pump and Solar Battery System

Step 1
Identify a suitable area beside the pond to place your mini feature. Attach the black hose to the black hose connector on the mini feature figure and the other end onto the pump. Position the feature on the side of the pond where required and place the pump into the pond. Connect the end of the pump's power lead into the rear connector of the supplied solar panel and position the solar panel where it will recieve the sun's light for the longest, see steps 2 and 3. The feature will now start to work once the solar panel has recieved enough charge from the sun.

Remember that your feature will pulse water and not run continuously due to its innovative pulse technology which means the feature and its battery will run for longer, see step 4.

Please note that Sidney Stoat is designed to sit on the side of the pond only and not in the water. Do not submerge the solar panel into the water.

Step 2
Join the bracket, tube and spike together and then attach the solar panel to the bracket. Slide the bracket into the bracket slot in the backside of solar panel.

You can also find a short tube with screws holes in the tube base. This part is provided for wall mounting if need it.

Step 3
Insert the spike into the ground. Position the solar panel to face South as much as possible to make the most of the daylight hours. It’s important to locate the solar panel in the place where the solar panel is not shaded by trees, thrubs or buildings.

Step 4
Solar Powered Pulse Timing Function:
The mini water features are designed to spout water intermittently and the pump will work at a pulse timing mode of approximately 2 seconds on and 5 seconds off as long as the battery has received enough charge from the solar panel. Positioning your solar panel correctly is very important as this will supply your battery with its maximum charge as shown in step 3

Setting up the Sidney Stoat water spitter and solar panel

Technical data

  • DC 6 Volt Low Voltage Pump
  • Pump: 0.72 Watts
  • 150lt/hr (48gal/hr)
  • 71cm (2'4") max head
  • 200cm low voltage cable for pump
  • CE approved IP68 for pump
  • Solar Panel 0.8 Watt - 5 volt - 160mA
  • Ni-MH batter pack AAA 3.6 Volt/300mA
  • 40.5cm (H)ground spike
  • Assembled solar panel IP44 CE approved

Pack dimensions
18.5cm (H) x 33cm (W) x 19cm (D)
Feature Dimentions
22cm (H) x 10.5cm (W) x 14cm (D)

Mains Free

Unique, quick recharge technology

Liberty water features and fountain pumps are run by a rechargeable Lithium battery and…

Solar Upgrade

Run & recharge system

The Liberty Solar Panel upgrade is designed as an additional power source for the battery-run…

Timer Functions

Pre-programmed running times

Run your Liberty Feature or pond pump with the pre-programmed running times or continually…

Varied Styles

Beautiful designs for all tastes

A variety of sizes and styles from classical to contemporary to suit any garden

Are you looking for a larger feature to keep fish or set up a pond?

Facebook
Where to buy
Subscribe to our Newsletter